By submitting the Airo Mechanical Service Request the requestor acknowledges that they agree and fully understand the above service request guidelines.
*Additional charges will apply if service is performed by Airo Mechanical or it's representatives that is not covered under workmanship or manufacturer warranty.
Service requests are to be submitted only after the required maintenance pre-checks are performed.
.The following pre-checks are required by maintenance personnel:
Make sure that the filter is clean, if a pleated filter is used, make sure that the filter is not too dense and obstructing the air flow.
Make sure that the drain is clean and that the float switch in the drain pan is not tripped. A presence of water in the drain pan is an indicator.
Make sure that you have main power to the unit. Check for a tripped breaker and the outdoor disconnect is in place and secure.
Make sure that the thermostat is on, that the resident understands the operation and that the thermostat has not been mistakenly mis-configured. Verify that the outdoor unit is not in delay, a flashing degree symbol or a flashing mode (cool or heat) on the thermostat indicates this.
Make sure that the evaporator coil (indoor) and the condenser (outdoor) coils are clean.
Verify that there is no damage such as wiring breaks due to landscaping or pets or accidental damage to the outdoor coil.
Verify that electrical connections to thermostat, contactor, etc. are in place and secure.
The above checks are an important part of your properties maintenance requirement and should be performed on a regular schedule. Failure to follow a maintenance schedule could result in equipment failure and also void the warranty on the equipment.
By submitting the service request the requestor verifies that the required pre-checks were performed by maintenance personnel, that the personnel are suitably certified, trained and qualified, and follow industry standard HVAC diagnostic procedures.